Reset device, Eset using the web-based user interface (see, Reset – Extron Electronics SMD 101 User Guide User Manual

Page 48: Device, Or using the web-based user interface (see

Advertising
background image

To set, change, or clear a user password you must be logged on as an admin.

1.

Click

Clear

to clear a previous password, then type a password in the

User

Password:

field. If this is the first time a password is set, type the password in the

User

Password:

field.

2.

Duplicate the password in the

Confirm

Password:

field.

3.

Click

Save

.

Reset Device

Provides several options to reset the SMD 101 if hardware or software conditions require.

NOTE: Proceed with caution. Some reset modes intentionally delete all user files,

media content, and settings from internal memory.

Figure 39.

Device Reset, Reset Options

•

Reset Device settings to default — Resets all hardware and software to default
condition, but retains user files and IP settings for communication.

•

Reset Device settings and delete internal user files (Retains all IP settings) —
Resets all hardware and software to default condition, deletes user files stored in
internal memory, and retains IP settings for communication.

•

Reset Device settings, delete internal user files, and reset all IP settings —
Resets all hardware and software to default condition including IP settings.

NOTE: If the control PC is connected via the Ethernet port, communications is

broken. Use the default IP address (192.168.254.254), the front panel config port,
or the rear panel RS-232 port to reconnect.

To select a reset, click the button to the left of the desired option. The radio button lights.
Click

Apply

to begin the reset. See the

SMD 101 Reset Summary

on page 83 for a

comparison of the reset modes.

SMD 101 • Web-based User Interface

42

Advertising