Extron Electronics SMD 101 User Guide - Manual (Page 61)

Use the templates below to connect the SMD 101 player to SME 100 encoder streams.
Substitute the SME 100 IP address for
<SME100_IP> .
PULL Streaming: URL
RTSP Unicast RTSP://< SME100_IP >/extron
RTSP Multicast RTSP://< SME100_IP >/extron
or
HTTP://<
SME100_IP >/web/multicast.sdp
Table 1. Pull Stream URLs
PUSH Streaming:
Unicast
TS/UDP UDP://@:<DESTINATION_PORT>
TS/RTP RTP://@:<DESTINATION_PORT>
ES/RTP HTTP://<SME100_IP>/web/output1.sdp
Multicast (<DESTINATION IP> address must be the multicast IP address)
TS/UDP UDP://@<DESTINATION_IP>:<DESTINATION_PORT>
TS/RTP RTP://@<DESTINATION_IP>:<DESTINATION_PORT>
ES/RTP HTTP://< SME100_IP >/web/output1.sdp
Table 2. Push Stream URLs
NOTES:
• <SME100_IP> is the IP address of the SME 100 encoder.
• UDP and RTP DESTINATION_PORT default is 60000.
• For ES/RTP, SAP is available in "Video only" stream mode.
4. Add the SME 100 user name and password.
http://admin:[email protected]/web/extron.sdp
http:192.168.254.254/web/extron.sdp
5. Press <Enter> to load the stream.
The stream loads. If Load Play is active, the stream begins playing. If Load Play is not active,
press play (see
Player Controls on page 16) to play the stream.
SMD 101 • Advanced Player Configuration 55