Gotham Incito DMX512_RDM Field Rev. F - Manual (Page 3)

CJ520003 Rev. F
©2012 Acuity Brands Lighting, Inc.
All Rights Reserved.
3 of 12
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory
statements.
Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and
Conditions, please visit www.acuitybrands.com.
 Never connect components under load.
 Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire
insulation.
 Unless individual product specifications deem otherwise: Never connect an LED product directly to a
dimmer packs, occupancy sensors, timing devices, or other related control devices. LED fixtures must be
powered directly off a switched circuit.
 Unless individual product specifications deem otherwise: Do not restrict fixture ventilation. Allow for
some volume of airspace around fixture. Avoid covering LED fixtures with insulation, foam, or other
material that will prevent convection or conduction cooling.
 Unless individual product specifications deem otherwise: Do not exceed fixtures maximum ambient
temperature.
 Only use fixture in its intended location.
 LED products are Polarity Sensitive. Ensure proper Polarity before installation.
 Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be
worn during all installation or servicing of the unit.
 Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter
performance.
 Some components inside the fixture may not be serviceable. In the unlikely event your unit may require
service, stop using the unit immediately and contact an ABL representative for assistance.
 Always read the fixtures complete installation instructions prior to installation for any additional fixture
specific warnings.
CAUTION: RISK OF PRODUCT DAMAGE