Imetec PIUMA NEXT CYCLONIC 1300W PARQUET - Manual (Page 20)

EN
12
ACCESSORIES
Combination carpet/floor brush (6)
Adjust the combination brush according to the type of flooring, using the toggle switch (6A)
[Fig. C1]:
• toggle switch (6A) position A
(extended bristles): for hard floors [Fig. C1-A]
• toggle switch (6A) position B (retracted bristles): for rugs and carpets
[Fig. C1-B]
Your appliance is equipped with the following attachments:
• Crevice tool (5A): to clean corners and crevices, such as radiators, skirting boards
and blinds;
• Upholstery tool (5B): to clean sofas, armchairs, upholstered chairs and curtains;
• Parquet brush (5C): special brush to clean parquet floors.
USE
Fully unwind the power cable (4). To this end, turn the upper cable hook (2A) downwards
[FIG. D1].
Using the vacuum cleaner with the cable fully or partly wound involves an
overheating hazard!
NOTE:
1. Bear in mind that a new appliance can develop odours the first few times it is
used. These odours are harmless and disappear shortly afterwards. Ventilate
the room.
2. With use, transparent parts can become opaque.
Insert the plug into the socket, holding the appliance by the handle to prevent it from falling
in the event that it was not stored in OFF position.
Press the ON/OFF button (11) once to turn the vacuum cleaner on or off [Fig. E1]:
The electronic power control (10) allows adjusting the suction force [Fig. E2]:
Minimum: for curtains, fine and delicate fabrics
Medium: ideal for cleaning sofas, armchairs, upholstered chairs, rugs and carpets
Maximum: for smooth floors.
Switch the appliance off after use, by pressing the ON-OFF button (11) and disconnect
the plug from the socket.
Wind the power cable (4) around the two hooks (2A and 2B) [FIG. D1] and fasten the plug
to the cable using the rubber clamp on the plug.
MI000889_IT-EN.indd 12 6/6/12 11:00 AM