Imetec PIUMA NEXT CYCLONIC 1300W PARQUET - Manual (Page 22)

EN
14
Cleaning the filtering system (8B+8C):
• Pull the dust compartment lever (9) [FIG. F1] and remove the dust collection system (8)
from the appliance [FIG. F2].
• Remove the filtering system (8B+8C) [FIG F3].
• Detach the filter grille (8B) turning it clockwise and remove it [FIG. F5].
• Clean the filter (8C) and filter grille (8B) shaking and brushing the dust off with care.
Use a soft brush to prevent any damage.
• If the filter (8C) is clogged by dust, wash it thoroughly with water. Take care not to
damage the filter and let it dry completely.
IMPORTANT!
Let the filter dry for at least 24 hours after washing it. Do not reinstall the
filter if it is damp!
• Insert the filter grille (8B) on the filter (8C), aligning the two arrows and fasten it by
turning it anticlockwise [FIG. F5].
• Reinstall the filtering system (8B+8C) in the dust compartment (8A).
• Fit the dust collection system (8), inserting the lower part into its guide [FIG. F2].
• Press the upper part of the dust compartment cover until it snaps into place, which
indicates that the dust compartment lever is properly locked (9).
If suction has not increased after cleaning the dust compartment (8A) and filtering system
(8B+8C), change the filter (8C).
Replacing the filter (8C):
NOTE:
• Replace the filter in the event it is damaged or impossible to clean.
• Replace the filter at least once a year.
• Failure to clean or replace the filter will make the manufacturer’s warranty null
and void.
• Pull the dust compartment lever (9) [FIG. F1] and remove the dust collection system (8)
from the appliance [FIG. F2].
• Remove the filtering system (8B+8C) [FIG F3].
• Turn the filter grille (8B) clockwise and remove it [FIG. F5].
• Replace the filter (8C) with a new one [FIG. F6].
• Insert the filter grille (8B) on the filter (8C), aligning the two arrows and fasten it by
turning it anticlockwise [FIG. F5].
• Reinstall the filtering system (8B+8C) in the dust compartment (8A) [FIG F3].
• Fit the dust collection system (8), inserting the lower part into its guide [FIG. F2].
• Press the upper part of the dust compartment cover until it snaps into place, which
indicates that the dust compartment lever is properly locked (9).
MI000889_IT-EN.indd 14 6/6/12 11:00 AM