Xoro HTC 1525D - Manual (Page 50)

6
Engl
ish
Connection
Power connection
Connect the AC/DC power adapter with the DC IN
input of the HTC TV set. After than, please connect the
power cable with the wall mounted power outlet.
On the front side you can see a red LED light. The
HTC TV set is now in Stand-By mode. By pressing the
POWER button on the remote control or on the top
side of the device the red LED changes to a green
light.
Antenna
The HTC TV set has an analogue and a digital TV
Tuner inside. For receiving analogue TV signals please
connect the antenna cable with the RF connector on
the HTC TV set and with the VHF/UHF roof antenna or
with a CATV antenna plug.
For receiving digital terrestical TV signals please connect the
HTC TV set with the RF plug and also with the roof antenna. If
no roof antenna is available, please use indoor aerial.
For activating the analogue TV Tuner, please switch with the
Source button to „TV“. For viewing DVB-T, please change with
the SOURCE button to „DVB“.
Note:
For getting the best DVB-T reception please uses the roof
antenna. If not possible, than you can connect the HTC TV set
with an active indoor aerial.
SCART Input
Audio– and Video signals from a VCR or a setop box can be
transmitted by SCART. Please connect a SCART cable with the
SCART input on the HTC TV set and with the SCART output on
the VCR or setop box.
Press the SOURCE button again until „SCART“ appears on the
screen and the SCART interface is activated.
CVBS Video– and Stereo Audio input
If you uses more than one multimedia terminals and the SCART,
HDMI and S-Video connection are used, than you connect the
next device by the audio/video component input. Please connect
the yellow wire of an 3-pin component cable with the VIDEO input
of the HTC TV set and the multimedia device. With this kind of
connection only video signals are transmitted. For listening sound
on the TV you should establish also a sound connection.
Please connect the white and red wire of the 3-pin component
cable with the AUDIO IN L / R and the correspondent audio out on
the multimedia device.