Safety - section a – Gorman-Rupp Pumps 06C1-GA 1005575 and up User Manual

Page 6

Advertising
background image

0 SERIES

OM−01247

PAGE A − 1

SAFETY

SAFETY − SECTION A

This information applies to 0 Series
power take-off driven pumps. Refer to
the manual accompanying the vehicle
before attempting to begin operation.

Before attempting to open or service the
pump:

1. Familiarize yourself with this man-

ual.

2. Switch off the vehicle ignition and

remove the key to ensure that the
pump will remain inoperative.

3. Allow the pump to completely cool

if overheated.

4. Check the temperature before

opening any covers, plates, or
plugs.

5. Close the suction and discharge

valves.

6. Vent the pump slowly and cau-

tiously.

7. Drain the pump.

This pump is designed for vehicular
mounting in petroleum service. Do not
attempt to pump corrosive materials, or
any liquids which may damage the
pump or endanger personnel as a result
of pump failure.

If this pump is used with volatile and/or
flammable liquids, be certain proper
safety practices are followed before op-

erating or servicing the pump. Provide
adequate ventilation, prohibit smoking,
wear static-resistant clothing and
shoes. Clean up all fuel spills immedi-
ately after occurrence.

Use lifting and moving equipment in good re-
pair and with adequate capacity to prevent inju-
ries to personnel or damage to equipment. Suc-
tion and discharge hoses and piping must be re-
moved from the pump before lifting.

After the pump has been positioned, make cer-
tain that the pump and all piping connections
are tight, properly supported and secure before
operation.

Do not operate the pump without the guards in
place over the rotating parts. Exposed rotating
parts can catch clothing, fingers, or tools, caus-
ing severe injury to personnel.

Do not operate the pump against a
closed discharge valve for long periods
of time. If operated against a closed dis-
charge valve, pump components will
deteriorate, and the liquid could come
to a boil, build pressure, and cause the
pump casing to rupture or explode.

If this pump is used with volatile and/or
flammable liquids, overheating may
produce dangerous fumes. Take pre-

Advertising