Gorman-Rupp Pumps T6B60S-B /F,/FM - Manual (Page 30)

OM-05604 SUPER T SERIES
MAINTENANCE & REPAIR PAGE E - 8
TEE
APPROX. 6 IN.
(152 MM) LONG
APPROX. 14 IN.
(356 MM) LONG
Figure 4. Rotating Assembly Tool
To install the tool, remove the vented plug (6, Figure
2) from the bearing housing, and screw the longest
length of pipe into the vent hole until fully engaged.
Install the tee, and screw the handles into the tee.
Use caution when lifting the rotating assembly to
avoid injury to personnel or damage to the assem­
bly.
Remove the bearing housing O‐ring (8).
Impeller Removal
(Figure 2)
With the rotating assembly removed from the
pump casing, unscrew the impeller from the shaft.
Use caution when unscrewing the impeller; ten­
sion on the shaft seal spring will be released as the
impeller is removed. Inspect the impeller and re­
place if cracked or badly worn.
Remove the impeller adjusting shims (28); tie and
tag the shims, or measure and record their thick­
ness for ease of reassembly.
Seal Removal
(Figure 2)
Slide the shaft sleeve and rotating portion of the
seal off the shaft as a unit.
Use a pair of stiff wires with hooked ends to remove
the stationary element and seat.
An alternate method of removing the stationary
seal components is to remove the hardware (20
and 21) and separate the seal plate (22) and gas­
ket (3) from the bearing housing (5). Position the
seal plate on a flat surface with the impeller side
down. Use a wooden dowel or other suitable tool to
press on the back side of the stationary seat until
the seat, O‐rings, and stationary element can be
removed.
Remove the shaft sleeve O‐ring (29).
If no further disassembly is required, refer to Seal
Installation.
Shaft and Bearing Removal and Disassembly
(Figure 2)
When the pump is properly operated and main­
tained, the bearing housing should not require dis­
assembly. Disassemble the shaft and bearings
only when there is evidence of wear or damage.
Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly‐
equipped shop by qualified personnel.
Remove the bearing housing drain plug (24) and
drain the lubricant. Clean and reinstall the drain
plug.
Disengage the hardware (15 and 16) and slide the
bearing cap (10) and oil seal (13) off the shaft. Re­
move the bearing cap gasket (17), and press the oil
seal from the bearing cap.
Place a block of wood against the impeller end of
the shaft and tap the shaft (12) and assembled
bearings (4 and 9) from the bearing housing.
Pry or press the oil seals (18 and 19) from the bear­
ing housing.
After removing the shaft and bearings, clean and
inspect the bearings in place as follows.
To prevent damage during removal from
the shaft, it is recommended that bearings