Gorman-Rupp Pumps T6B60S-B /F,/FM - Manual (Page 38)

OM-05604 SUPER T SERIES
MAINTENANCE & REPAIR PAGE E - 16
larly through the sight gauge (25) and maintain it at
the middle of the gauge. When lubrication is re­
quired, add SAE No. 30 non‐detergent
oil through
the hole for the air vent (7). Do not over‐lubricate.
Over‐lubrication can cause the bearings to over‐
heat, resulting in premature bearing failure.
NOTE
The white reflector in the sight gauge must be posi­
tioned horizontally to provide proper drainage.
Under normal conditions, drain the bearing hous­
ing once each year and refill with approximately 24
ounces (0,7 liter) clean oil. Change the oil more fre­
quently if the pump is operated continuously or in­
stalled in an environment with rapid temperature
change.
Monitor the condition of the bearing lubri­
cant regularly for evidence of rust or mois­
ture condensation. This is especially im­
portant in areas where variable hot and
cold temperatures are common.
For cold weather operation, consult the factory or a
lubricant supplier for the recommended grade of
oil.
Power Source
Consult the literature supplied with the power
source, or contact your local power source repre­
sentative.