ABUS TVIP10055B - Manual (Page 26)

26
Key length: With WEP only. Select the bit length for the key here.
Network key: With WEP only. Up to four keys can be assigned.
Obtain IP address automatically:
The IP address, subnet mask, and address for the default gateway are
obtained automatically from a DHCP server. An activated DHCP server
must be present in the network in this case.
Use the following IP address: Manual setting of the IP address, subnet mask, and standard router
(gateway)
Use the following DNS server address:
If the DNS server address is not automatically assigned by
a DHCP server, it can be manually assigned here.
Primary DNS server: First server address with which the camera attempts to
convert DNS names into IP addresses.
Secondary DNS server: Alternative server address with which the camera attempts
to convert DNS names into IP addresses.
Accept the settings by pressing “SAVE” or cancel them by pressing “Cancel”.
WPS (TVIP10055B only)
WPS (Wi-Fi Protected Setup) is a simple method for establishing a secure wireless network connection
(WPA, WPA2). Consult the manual for your access point (e.g. router with WPS function) regarding the
necessary steps for setting up the WPS function.
WPS:
Enable the WPS function here if required.
MAC address: Shows the MAC address of the wireless interface.
IP address: The set IP address is displayed here. The address can be assigned automatically
(DHCP) or manually (see below).
Configure via:
PBC:
Push Button Configuration – You set up a secure wireless connection by pressing
the button on the access point or network camera.
PIN: