ABUS TVVR41210 Operating instructions - Manual (Page 78)

Live view
78
Settings
Note
The live view can be set as follows.
Open the main menu, then click on “Configuration”. Then
click on “Liveview”:
The following settings are available in the TAB “General”:
Video Output In-
terface VGA/HDMI, Main CVBS
Select the connection where the set-
tings are changed
Live View Mode Different camera layouts
Dwell Time Switching time between the individu-
al cameras and the sequence dis-
play
Audio Activate audio
Display status
bar Activate/deactivate the status bar
Event Output Allocate monitor for the output of
events
Full Screen
Monitoring Dura-
tion in seconds, where the event on the
allocated monitor will be displayed.
Post Event Dis-
play Time in seconds, the duration of the Pop-
up window when an event occurs.
NoteVGA monitor connected:
A connected VGA monitor automatically becomes
the main monitor where the audio output is also
assigned.
No HDMI monitor connected
If during the boot process of the DVR the HDMI cable is not
connected, the main video signal is displayed at VGA output .
Connect the HDMI cable and reboot the DVR in order to dis-
play the main video signal at the HDMI output.
Setting the camera output
You can display a maximum of 16 cameras simultane-
ously in the live view.
1. Click on the TAB “View”.
2. Select the display mode
(depends on the model)

1 x 1

2 x 2

1 + 5

1 + 7

3 x 3

4 x 4
3. The camera signal is assigned to the corresponding
image section using the navigation keys.
 “X” means that this camera is not displayed.
4. Click on Apply to accept the settings.