Aeromotive 14137 - 04-06 SUBARU 2.5L STI FUEL RAIL SYSTEM User Manual
Page 5
23. Place each of the Aeromotive fuel rail / injector assemblies onto each of the tumbler
valves, being sure to align the bottom of the fuel rail with the injector bores in the
tumbler valve.
24. Reinstall the fuel rail mounting bolts and tighten.
25. Position the intake manifold assembly on the engine.
26. Find suitable place in the vehicle’s engine compartment to mount the Aeromotive
regulator, typically on or near the passenger side strut tower. Using the supplied
mounting bracket as a template, mark the bracket mounting holes and drill to accept a
#10 screw.
27. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle
using two #10 screws, nuts and lock washers.
28. Install one AN-10 o-ring on each of the two AN-10/AN-8 cutoff tapered flare fittings and
one o-ring on the AN-06 union fitting. Thread the side of the AN-10/AN-8 cutoff tapered
fitting with the o-ring into each of the two AN-10 ports on the regulator. Also thread the
AN-6 cutoff tapered flare into the bottom of the regulator.
29. Install one AN-08 o-ring on each of the two AN-8 cutoff tapered flare fittings.
30. Install one AN-08 o-ring on the AN-8 90-degree male ORB hose ends.