Aeromotive 14136 - 04-06 SUBARU 2.5L STI FUEL RAIL KIT - Manual (Page 5)

23. Place each of the Aeromotive fuel rail / injector assemblies onto each of the tumbler
valves, being sure to align the bottom of the fuel rail with the injector bores in the
tumbler valve.
24. Reinstall the fuel rail mounting bolts and tighten.
25. Reinstall intake manifold assembly replacing gaskets and retightening bolts as outlined in
factory service manual.
Note: When reinstalling he tumbler valve / intake manifold assembly locate the sensor on the
passenger side of the block directly behind the fuel rail and connect the wiring. With the bolts
installed loosely in the tumbler valves make sure there is clearance between the plug in the back
side of the fuel rail and the sensor by sliding the tumbler valve assembly forward then torque down
the tumbler valves as outline in the service manual.
26. Using an after-market fuel pressure regulator, Aeromotive p/n 13101 or 13109 or similar,
in conjunction with high pressure fuel lines and fittings, plumb the reminder of the fuel
system.
Ensure the any spilled gasoline and any gasoline soaked shop towels are cleaned up and removed from
the vicinity of the vehicle!
27. Reinstall any electrical wiring, vacuum lines, fuel lines and throttle body components that
where removed for the original fuel rail removal.
28. Refill engine coolant and check system for leaks