Aeromotive 14124 - 05-09 4.6L 3-VALVE GT FUEL RAIL SYSTEM - Manual (Page 4)

23. Connect one AN-08 45-degree hose end to the front of the passenger side fuel rail. Connect one AN-
08 90-degree hose end to the front of the driver side fuel rail. Connect one AN-08 Straight hose end
to the passenger side of the fuel pressure sensor adapter and connect one AN-08 90-degree hose
end to the driver side of the fuel pressure sensor adapter. Plan a route for each of the two lines
between the fuel pressure sensor adapter and the fuel rails, measure the two lengths of fuel line
needed. See section titled Hose and Fitting Assembly for fuel line assembly instructions. Once the
hoses are assembled, ensure there is no debris in the hose and install them.
24. Inspect the OEM fuel supply line o-rings and replace if necessary. Place a light coat of oil on the fuel
supply line o-rings and the supply line adapter fitting to ease installation. Connect the AN-08 tee
adapter fitting to the OEM fuel supply line.
25. Using the remaining AN-08 hose end fittings as a guide, measure the required fuel line lengths
needed and make up the last two required AN-08 fuel supply lines (See section titled Hose and
Fitting Assembly). A typical configuration is pictured below.