Aeromotive 14102 - 86-95 5.0L GT & COBRA FUEL RAIL SYSTEM - Manual (Page 5)

35. Connect one AN-06 straight hose end to each of the two ports on the fuel pressure regulator.
Connect one AN-06 90-degree hose end to each of the AN-08/AN-06 reducer unions on the fuel rails.
Plan a route for each of the two lines between the fuel pressure regulator and the fuel rails, measure
the two lengths of fuel line needed. See section titled Hose and Fitting Assembly for fuel line
assembly instructions. Once the hoses are assembled, ensure there is no debris in the hose and
install them.
36. Inspect the OEM fuel supply line o-rings and replace if necessary. Place a light coat of oil on the fuel
supply line o-rings and the supply line adapter fitting to ease installation. Connect the AN-08 tee
adapter fitting to the OEM fuel supply line.
37. Using the remaining AN-08 hose end fittings as a guide, measure the required fuel line lengths
needed and make up the last two required AN-08 fuel supply lines (See section titled Hose and
Fitting Assembly). A typical configuration is pictured below.
38. Reassemble the vehicle using the reverse of the foregoing removal procedure.
Please note, due to the wide range of applications and varying OEM and after market component
tolerances it has been found in a few isolated cases it is necessary to install a 3/8” thick spacer between
the upper and lower intake manifolds. This will allow you to gain clearance between the top of the fuel