Aeromotive 17242 - A1000 CARBURETED FUEL SYSTEM (SINGLE CARB) - Manual (Page 3)

Section 1 - Fuel Pump Installation:
1-1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system
pressure.
1-2. Raise the vehicle and support it with jack stands.
1-3. Referring to the appropriate vehicle service manual for instructions, drain, disconnect any electrical and fuel
component connections.
1-4. In the kit find two AN-10 cutoff union fittings and four of the AN-10 o-rings. Install each of the four o-rings on each
end of the two AN-10 cutoff union fittings.
1-5. Install each of the two fittings into each end of the provided Aeromotive fuel pump.
1-6. Noting the appropriate flow directions, install the provided fuel filter, Aeromotive p/n 12301, on the fuel pump outlet
and the other fuel filter, Aeromotive p/n 12304, on the fuel pump inlet. If you get the two filters mixed-up, the 12304
filter will have a 100 micron stainless steel filter element inside, where as the 12301 will have a 10 micron paper filter
element inside.