Aeromotive 17203 - A2000 CARBURETED FUEL SYSTEM (SINGLE CARB) User Manual
Page 6
2-7. Thread the AN-06 fittings with the o-rings into the sides of the fuel pressure regulator.
2-8. Place the crush rings on the Dual feed carburetor to AN-06 adapter fittings. Thread each of the two fittings into each
of the carburetor float bowls and tighten.
2-9. Using one of the supplied 90-degree AN-06 hose ends and one of the supplied AN-06 straight hose ends as a guide,
measure the length of AN-06 steel braided line needed to connect the regulator to the carburetor. Repeat this for
second supply line.
2-10. Cut and assemble the two steel braided hoses and hose ends as shown in Section 3.
2-11. Attach the fuel supply lines to the carburetor and tighten.
2-12. Once the regulator is installed, attach a suitable fuel pressure gauge to the 1/8 NPT port on the fuel pressure
regulator.
2-13. Ensure that any spilled gasoline and any gasoline soaked shop towels are cleaned up and removed from
the vicinity of the vehicle!