Aeromotive 17126 - ELIMINATOR EFI FUEL SYSTEM User Manual

Page 3

Advertising
background image

Section 1 - Fuel Pump Installation:

1-1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system

pressure.


1-2. Raise the vehicle and support it with jack stands.

1-3. Referring to the appropriate vehicle service manual for instructions, drain, disconnect any electrical and fuel

component connections.


1-4. In the kit find one AN-10 and one AN-12 cutoff union fitting, two of the AN-10 o-rings and two of the AN-12 o-rings.

Install each pair of o-rings on the appropriate union fitting.

1-5. Install each of the two fittings into the appropriate end of the provided Aeromotive fuel pump.

1-6. Noting the appropriate flow directions, install the provided AN-10 fuel filter, Aeromotive p/n 12301, on the fuel pump

outlet and the AN-12 fuel filter, Aeromotive p/n 12302, on the fuel pump inlet.

Advertising