Aeromotive 13113 - BELT_HEX DRIVE EFI REGULATOR - Manual (Page 2)

3. Find a suitable place in the vehicle’s engine compartment to mount the Aeromotive regulator. Using
the supplied mounting bracket as a template, mark the bracket mounting holes and drill to accept a
#10 screw.
4. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two
#10 screws, nuts and lock washers.
5. Attach the fuel supply line to the AN-10 inlet port located in the front of the regulator using AN-10
style fittings and o-rings.
6. Attach the fuel return line to the AN-10 bypass port located at the bottom of the regulator using a
cutoff AN-10 style fitting (Aeromotive P/N 15608 or equivalent) and o-ring.
7. Attach the fuel supply line(s) to the fuel system using AN-08 style fittings and o-rings. Install AN-08
style plugs and o-rings into the outlet ports not used.
8. Tighten all connections.
9. Once the regulator is installed, attach a suitable fuel pressure gauge in the fuel system.
10. Ensure that any spilled gasoline and any gasoline soaked shop towels are cleaned up and
removed from the vicinity of the vehicle!
11. Reconnect the battery and turn the fuel pump ON WITHOUT starting the car. After several seconds,
check the fuel pressure. If there is no fuel pressure, turn the fuel pump OFF, wait one minute, return
the fuel pump ON, and recheck the fuel pressure. Repeat this OFF and ON procedure until the fuel
pressure gauge registers fuel pressure.
By-pass port
(Bottom of regulator)
Inlet / Outlet Ports
Boost / Vacuum Port