Aeromotive 13217 - STACKABLE CARBURETED REGULATOR - Manual (Page 2)

3. Find a suitable place in the vehicle’s engine compartment to mount the Aeromotive regulator. Using
two flange mounting holes as a template, fabricate a bracket mounting.
4. If using more than one regulator, place the supplied o-ring in the o-ring groove on one of the
regulator bodies. Using the two supplied mounting screws connect the regulators together. Insure
that the o-ring does not slip out of the o-ring groove and get pinched during assembly.
5. Attach the fuel supply line to the regulators AN-10 inlet port (located at the front or rear of the
regulator) using AN style fittings and o-rings.
AN-12 / AN-10 fitting, Aeromotive P/N 15642
AN-10 / AN-10 fitting, Aeromotive P/N 15608
AN-08 / AN-10 fitting, Aeromotive P/N 15610
AN-06 / AN-10 fitting, Aeromotive P/N 15609
Mounting Screws
Sealing O-Ring
O-Ring Groove
Static / Dead Head Configuration