Alpha Technologies Rear Access Bullet Breaker Panel, 19 - Manual (Page 9)

Argus Technologies Ltd. 020-671-C0 Rev A WC
Printed in Canada. © 2007 Argus Technologies Ltd. ARGUS is a registered trademark of Argus Technologies Ltd. All Rights Reserved. Page 1 of 7
1 Introduction
1.1 Scope of the Manual
This instruction manual explains the installation and interconnection of Argus Technologies’ Rear Access Bullet
Breaker Panel.
NOTE: To aid the user with installation, frequent reference is made to foldout drawings located at the rear of the manual.
1.2 Product Overview
Argus designed this panel for load circuit protection suitable for small to large power applications. Up to 24 plug-in
breakers can be installed in a 23” rack model; 18 in a 19” rack. A dual feed option changes the number of
positions to 2x11 and 2x8 respectively.
Breakers from 5 to 250A per position are available. When installed, breaker access is made via the drop-down
front cover.
A breaker alarm indicator (one per feed) is located on the front cover. See Figure 1 below.
The compact unit installs in 3 RU and all distribution wires are connected at the rear via two-hole termination lugs
for cable or bus bar installation.
Figure 1–Rear Access Bullet Breaker Panel
Front cover latch
(typical, 2 places)
Breaker alarm indicator
(single feed option)