Alpha Technologies Underground Battery Vault - Manual (Page 19)

031-040-B0-002 Rev. B
19
2. INSTALLATION
For the 165GXL battery, the cover locking mechanism fi ts
under the battery handle tab molded into the battery case. To
properly seat the cover, the battery handle must be pushed
down as shown to allow space for the cover latch to engage
at “X”.
X
X
For the 180 GXL battery, the carry strap does not need to be
pushed down. The cover will latch at “X”.
Place the cover over the battery, route the battery cables and
battery sense wires down through the molded channels in the
cover.
Flex the side panels out and place the cover over the battery.
The cover will snap into place.
Press down evenly and fi rmly on the cover to fully seat it in place.
Repeat for the rest of the batteries in the string.
To ensure the battery covers are properly seated, pull up on
the center of the cover. If the cover comes off, repeat the above
steps.
2.4 Battery Covers, continued
2.4.1 Installing the Battery covers