Alpha Technologies UPE-M Series - Manual (Page 27)

27 031-145-C0-002 Rev. B
KEPS
Nuts
3.0 Installation, continued
3.5 Power Supply Installation
Tools Needed:
11/32” nut driver (see step 2)
Procedure:
1. The upper tray of the enclosure has five dimples that line up with the feet of the XMS2 power
supply. The feet of the power supply must rest in these dimples so the ventilation snorkel on
the front cover aligns with the fan to form a seal when the door is closed.
2. If a power supply other than Alpha’s XMS2 is used, remove the four (4) #8-32 Keps nuts
holding the ventilation snorkel to the inside of the front door and remove the snorkel.
3. Place the power supply on the top tray.