Alpha Technologies UPE-M Series - Manual (Page 28)

28 031-145-C0-002 Rev. B
3.0 Installation, continued
3.6 Power Supply Connections
1. Verify that the Battery Circuit Breaker is in the OFF position. Connect the red and black cable
from the battery pack to the Battery Input connection on the front of the power supply.
2. Connect the black and white wire leading from the Service Power Inserter (SPI) to the plug
labeled Output 1A on the front of the power supply. If a second SPI is installed, connect it to
Output 2.
3. Verify that the Input Breaker in the Service Entrance Panel is in the OFF position. Plug the
power supply’s AC power cord into the Input Power Panel (IPP) or Breaker Duplex Option
(BDO).
Fig. 3-12, Battery and Output Power Connections
OFF
Battery Circuit
Breaker
Battery Input
from Battery Pack
Power Supply Output to SPI