American Expedition Vehicles JK DualSport XT Suspension 2.5 User Manual
Page 5
Advertising
4
3.
Carefully lower the axle using the floor jack enough to remove
the springs. DO NOT overextend the wheel speed sensor or
locker wiring (A).
Remove the factory springs.
4.
Install the track bar tower. Tightening U-bolt to NO MORE than 40 ft lbs. Use supplied bolt and
washer in bottom hole (A) and tighten to 80 ft lbs. Install the new AEV track bar reusing the
factory hardware to install the track bar, reversing the direction of the hex bolt as shown (B).
DO NOT tighten at this point. (NOTE: for right hand drive vehicles, reinstall factory track bar)
Install AEV springs making sure to properly index them on the axle spring seat (C).
A.
A.
A.
B.
C.
REAR OF JEEP
Advertising