Atec Chroma-62000P Series - Manual (Page 2)

PROGRAMMING SEQUENCES APPLICATIONS
The 62000P Series supplies offer a wide operating region. For example, the output
specification for model 62012P-80-60 is 1200W/80V/60A, it allows operating flexibly in
various combinations as shown in the figure at the right. As shown conventional power
supplies provide the same rated current at all output voltages, however, the 62000P
provides greater current at lower output voltages. This means both low voltage/high
current and high voltage/low current UUTs can be tested using a single supply avoiding the
for multiple supplies saving cost and space within typical ATE systems.
When high power is required, it is common to
connect two or more power supplies in parallel
or series. The 62000P Series supplies have a
smar t Master / Slave control mode mak ing
s e r i e s/p a r a l l e l o p e r a t i o n f a s t a n d s i m p l e.
I n this mode the master scales values and
downloads data to slave units so programming
i s s i m p l e a n d c u r r e n t s h a r i n g a u t o m a t i c.
The 62000P Series supplies allow for 100 user programmable sequences with time settings ranging from 5ms to 15000s, voltage /
current slew rate control and 8 bit TTL output for automated test applications. Applications include DC/DC Converter & Inverter voltage
dropout testing, engine star t-up simulation, batter y automated charging, product life cycle testing and airborne avionics testing.
The 62000P Supplies provide 8
output TTL bits with timing control.
These control lines can be used for
VID control of VRM or to control
other discrete signals.
Soft Start Testing Voltage Step Waveform D/D Converter Sag Testing D/D Converter Surge Testing D/D Converter Cycle drop Testing
Pulse Charge of Battery Life Cycle Testing Line Regulation Testing Starting Profile of ISO 16750-2
MASTER/SLAVE PARALLEL & SERIAL CONTROL
WIDE OPERATING REGION WITH CONSTANT POWER
Reset Behavior at Voltage
Drop of ISO 16750-2