Atec Elgar-501b - Manual (Page 6)

Elgar ■ 1.800.733.5427 ■ 858.450.0085 ■ Fax 858.458.0267 ■ 9250 Brown Deer Road, San Diego, CA 92121 ■ www.elgar.com ■ email: [email protected] 25
SX S
ERIES
S
PECIFICATIONS
SPECIFICATIONS
OUTPUT
Voltage Range: 0-65/130/260 VAC (varies
per model). Specific output range is
selected by jumper change on rear panel.
Consult Elgar for other voltage ranges.
Rated Power Voltage Range: Full rated
VA from 55-65 VAC, 110-130 VAC, or
220-260 VAC over a ±10% input and rated
PF range. Continuous duty at 150% of
rated capacity at 55°C*
Load Power Factor: Unity to ±0.7 PF to
rated VA with an output voltage
adjustment range of 80-100% of full scale*
Frequency Range: 45 Hz to 1kHz
Total Harmonic Distortion:
0.5% from 45 Hz to 1 kHz with linear load
1.0% from 45 Hz to 75 Hz with pulsed load
4.0% from 75 Hz to 450 Hz with pulsed load
Load Regulation: ±1% from 45 Hz to
450 Hz with pulsed load or from 45 Hz to
1 kHz with linear load
Line Regulation: ±0.25% at rated load for
a ±10% input change at full scale output
voltage
Response Time: <2 ms
AC Noise Level: 70 dB below full output
voltage with input grounded
INPUT
Voltage: 115/208/230 VAC, ±10% (208 VAC
not available on 501 SX.) User selectable
(See model description on page 23)
Frequency: 47 to 63 Hz (400 Hz option,
special order)
Efficiency: Up to 45%
GENERAL
Operating Temperature Range: 0° to
+55°C
Operating Humidity Range: Up to 95%
non-condensing
Metering: 0 to 300 VAC output voltmeter,
±3% accuracy
Controls: Input power switch/circuit
breaker and pilot light. Full range, 10-turn
output voltage control potentiometer
* See power derating curve on page 23.
Single-Phase Output Power
Model Power Output Input Physical Comments
Total VA Vol. Range Max Current Frequency Range Voltage and Nominal/Max Height and Depth Weight
(RMS)L-N (RMS) 1 (Hz) Phase (kVA) 2 (in/mm) (lbs/kg)
501 SX-X4 500 0-65 11.5/36 45 to 1k 115 or 230, 1.5/2.2 5.25/133 H 80/36 Net
0-130 5.8/18 1ø 21/533 D 88/40 Ship
0-260 2.9/9
1001 SX-X4 1000 0-65 23.1/72 45 to 1k 115, 208 or 3.0/4.2 7.00/178 H 130/59 Net
0-130 11.5/36 230, 1ø 21/533 D 140/64 Ship
0-260 5.8/18
1751 SX-X4 1750 0-65 40.4/120 45 to 1k 115,108 or 5.2/7.5 12.25/311 H 195/89 Net
& 0-130 20.2/60 230, 1ø 21/533 D 205/93 Ship
1751 SXE-2X 0-260 10.1/30 1751 SXE-24 only
Dual-Phase Output Power
1000 SX-2-X4 1000 0-65 11.5/36 45 to 1k 115 or 230, 3.0/4.4 10.50/267 H 160/73 Net 2 ea 501 SX in 2ø 90°, 1ea 400 SR,
0-130 5.8/18 1ø 21/533 D 176/80 Ship 1ea signal cable
0-260 2.9/9
2000 SX-2-X4 2000 0-65 23.1/72 45 to 1k 115,208 or 6.0/8.4 14/356 H 260/118 Net 2ea 1001 SX in 2ø 90°, 1ea 400 SR,
0-130 11.5/36 230, 1ø 21/533 D 280/127 Ship 1ea signal cable
0-260 5.8/18
3500 SX-2-X4 3500 0-65 40.4/120 45 to 1k 115, 208 or 10.5/15.0 24.50/622 H 390/177 Net 2 ea 1751 SX or 1751 SXE in 2ø 90°,
& 0-130 20.2/60 230, 1ø 21/533 D 410/186 Ship 1 ea 400 SR, 1 ea signal cable
3500 SXE-2-2X 0-260 10.1/30 3500 SXE-2-24 only
Three-Phase Output Power
1500 SX-3-X4 1500 0-65 11.5/36 45 to 1k 115 or 230, 4.5/6.6 15.75/400 H 240/109 Net 3 ea 501 SX (4 wire Y),
0-130 5.8/18 1ø or 3ø 21/533 D 264/120 Ship 2 ea 400 SR, 1 ea signal cable
0-260 2.9/9
3000 SX-3-X4 3000 0-65 23.1/72 45 to 1k 115, 208 or 9.0/12.6 21/533 H 390/177 Net 3 ea 1001 SX (4 wire Y)
0-130 11.5/36 230, 1ø or 3ø 21/533 D 420/191 Ship 2 ea 400 SR, 1 ea signal cable
0-260 5.8/18
5250 SX-3-X4 5250 0-65 40.4/120 45 to 1k 115, 208 or 15.7/22.5 36.75/933 H 585/266 Net 3 ea 1751 SX or 1751 SXE (4 wire Y),
& 0-130 20.2/60 230, 1ø or 3ø 21/533 D 615/280 Ship 2 ea 400 SR, 1ea signal cable
5250 SXE-3-2X 0-260 10.1/30 5250 SXE-3-24 only
1
All SX models specified are at 150% of nominal output current into a linear resistive load.
2
Maximum volt/amps under worst case conditions of load and input line at 150% capacity.