Atec Fluke-430 Series - Manual

Pinpoint power problems faster,
safer and in greater detail
The Fluke 434 and 435 three-phase power quality
analyzers help you locate, predict, prevent and
troubleshoot problems in three- and single-phase
power distribution systems. Troubleshooting is
faster with on-screen display of trends and cap-
tured events, even while background recording
continues. The new IEC standards for flicker,
harmonics and power quality are built right in to
take the guess work out of power quality.
Fluke 430 Series
Three-Phase Power Quality Analyzers
Technical Data
•
Troubleshoot real-time: Analyze the trends
using the cursors and zoom tools-even while
background recording continues
•
Highest safety rating in the industry:
600 V CAT IV/1000 V CAT III rated for use at
the service entrance
•
Automatic Transient Mode: Capture 200 kHz
waveform data on all phases simultaneously
up to 6 kV
•
Fully Class-A compliant: Conduct tests
according to the stringent international IEC
61000-4-30 Class-A standard
•
Measure all three phases and neutral:
With included four current probes
• AutoTrend: Every measurement you see
is always automatically recorded, without
any setup
•
System-Monitor: Up to ten power quality
parameters on one screen according
to EN50160 power quality standard
•
Inrush mode: For troubleshooting nuisance
circuit breaker tripping
• View graphs and generate reports:
With included analysis software
•
Logger function: Configure for any test condi-
tion with memory for over 400 parameters at
user defined intervals
•
Mains signaling: Measure interference from
ripple control signals at specific frequencies
•
Battery Life: Seven hours operating time per
charge on NiMH battery pack
• Warranty: Rugged, handheld troubleshooter
with Fluke three-year warranty