Atec Kepco-EL Series - Manual (Page 5)

KEPCO, INC. • 131-38 Sanford Avenue • Flushing, NY 11355 USA • Tel: (718) 461-7000 • Fax: (718) 767-1102
Email: [email protected] • www.kepcopower.com
CONFIGURING AND OPERATING YOUR EL ELECTRONIC LOAD FRONT PANEL
(SINGLE CHANNEL)
CONTROLS AND INDICATORS
1. Power Switch
2. Current Display (Autorange)
3. Voltage Display (Autorange)
4. Power Display (Autorange)
5. Multifunction Control Knob
Press to Select Mode
Turn for Set Point
6. LOAD - Green for Standby
Amber for Engaged
Press to Engage/Disengage
Flashing Red for Fault
7. LED Constant Current Mode (CI)
8. LED Constant Resistance Mode (CR)
Blinks for Constant Conductance
Mode (CS)
9. LED Constant Voltage Mode (CV)
10. LED Constant Power Mode (CP)
11. LED LAN (Lit When LAN Connected)
12. LED Local
All Mode LEDs Blinking ON - Short
All Mode LEDs OFF - Mode Off
REAR PANEL
(DUAL CHANNEL, A & B)
LAYOUT AND CONNECTIONS
1. a-c Input
2. Remote Sense Terminals
3. External Analog Control
4.
Laminated Copper Buss
LOAD Connection
5. Ethernet Option
6. Master (Out to Slave)
7. Slave Input/Output
8. RS-232 Interface
9. USB Port
10. GPIB Option (Not Shown)
1 7 8 9
6 11 12
2
3
4
5
10
1 2A 3A 4A 2B 3B
10
A B
6
5
7
8
9
4B
Model EL 2K-600-60DE/Dual Channel Unit
This unit has all 6 FET modules in place.
Front Panel (Single Channel)
Rear Panel (Dual Channel, A & B)
UPGRADABLE AND DYNAMICALLY CONFIGURABLE
• Expand capability by adding Power FET modules
• Upgradable due to load's modular nature
• Interface enables field retrofits of firmware upgrades
ensuring system is up-to-date
• Ethernet option facilitates remote access