Atec Kepco-EL Series - Manual (Page 6)

TABLE OF SAMPLE SOFTWARE COMMANDS FROM OVER 1000 IN YOUR SYSTEM
NOTE: System responds to short forms of all commands and queries. See instruction manual for details.
Mode
Load ON/Load OFF
Set Parameter Value
Measure
Protection
Damping Selection
Transient Operation
ramps
Selection of operating mode
Engage/Disengage load with device under test
Set current, voltage, power, resistance, conductance values
Measure Voltage, Current, Power
Allows setting maximum parameter values to protect the
device under test as needed as well as minimum voltage
12 different damping settings to allow
optimizing the user's test
To create a transient input change to a new level
for a period of time and then return to the original setting.
Can also be used to create multiple transients.
To change the fast response time of the EL
(under 50 microseconds) to a period of
100 microseconds to 10 seconds.
MODE Current, MODE VOLTage, MODE POwer,
MODE rESistance, MODE CONDuctance,
MODE SHOrt, MODE OFF
INPut 1=ON, INPut 0=OFF
Current xxxx, POwer xxxx
MEASure:Current?, MEASure:VOLTage?
VOLTage:PrOTection:uNDer xxxx
VOLTage:PrOTection:OVEr xxxx
SYSTem:PFModule:DAMPing x,
SYSTem:DAMPing x
where x is a number from 0 to 5 (min - max)
Curr:TrAN 10,.1,5,8 create 8-5 second transients.
Each transient is .1 seconds at 10 amperes
then return to original set point for 4.9 seconds.
SYST:rAMP.1
This is an absolute time of change and not in
amperes per second to reduce calculation load
on the test software.
OPERATION MANAGEMENT
SYSTEM MANAGEMENT
List power FET modules installed in EL
Display FET temperatures, currents and fuse status
Turn external analog input OFF or to one of two inputs:
A high-speed hazardous input or isolated SELV
SYSTem:PFModule:LIST?
SYSTem:PFModule:STATus?
SYSTem:EXTernal 0 (disabled)
SYSTem:EXTernal 1 (hazardous enabled)
SYSTem:EXTernal 2 (isolated SELV enabled)
Power FET Modules Installed
Display Power FET Status
External Analog Control On/Off
PURPOSE COMMAND EXAMPLE FUNCTION
A 60KW
configuration.
Consists of one
5kW master and
11 5kW slaves.
3/4 View
Single Channel Unit
3/4 View
Dual Channel Unit
For more information visit
www.kepcopower.com/el.htm
KEPCO, INC. • 131-38 Sanford Avenue • Flushing, NY 11355 USA • Tel: (718) 461-7000 • Fax: (718) 767-1102
Email: [email protected] • www.kepcopower.com