B&K Precision 2658A - Manual - Manual (Page 44)

38
18.1 Selection of Storage Device
1. When is pushed, the built-in flash memory is selected as a storage device.
When is pushed, the external USB memory is selected as a storage device.
* Install the USB memory in USB A- plug on the right side firmly. Refer to the figure below.
* Once you disconnect, then reconnect the same or a different USB flash memory drive, the 2650A series
will not automatically recognize the new USB drive. After connecting the drive, you must first press the
Save/Load key, followed by F5 key (USB) in order for the 2650A to "see" the new drive., then proceed as
described below.
.
F1 F2 F3 F4 F5 F6
PRE
SET SAVE
MODE SELECT
LOAD DELETE
DEVICE
MEM USB
PRE
SET
F4
F5