Tips for saving energy, If required, use an insulating plate, Select 560 mm cavity depth – Neff G5614X6 DE User Manual

Page 30: Open the appliance as briefly as possible, Operating noises, Quite normal noises, Droning, Bubbling, humming or gurgling noises, Clicking, Preventing noises

Advertising
background image

en

30

Tips for saving energy

Install the appliance in a dry, well

ventilated room! The appliance should

not be installed in direct sunlight

or near a heat source (e.g. radiator,

cooker).
If required, use an insulating plate.

Select 560 mm cavity depth.
A smaller cavity depth will result in

a higher energy consumption.

Do not block the ventilation openings

in the appliance.

The ice packs slow down the thawing

process of the frozen food in the event

of a power failure or malfunction.

Place the ice packs directly on

the food in the top compartment.

Open the appliance as briefly as

possible!
The briefer the appliance door is

opened, the lower the ice formation

on the freezer shelves.

Thaw frozen food in the refrigerator

compartment and use the low

temperature of the frozen food to cool

refrigerated food.

Regularly defrost the freezer

compartment to remove the layer

of frost.
A layer of hoarfrost will impair

refrigeration of the frozen food

and increase power consumption.

Occasionally clean the rear

of the appliance to prevent an

increased power consumption.

The arrangement of the fittings

does not affect the energy rating of

the appliance.

Operating noises

Quite normal noises

Droning

Motors are running (e.g. refrigerating

units, fan).
Bubbling, humming or gurgling noises

Refrigerant is flowing through the tubing.
Clicking

Motor, switches or solenoid valves are

switching on/off.

Preventing noises

The appliance is not level

Please align the installation cavity with

a spirit level. To do this, use the

height-adjustable feet of the cavity

or place something underneath.
Containers or storage areas wobble

or stick

Please check the removable parts

and re-insert them correctly if required.
Receptacles are touching each other

Move the receptacles slightly away from

each other.

Advertising