Daymak Boomerbuggy Covered - Manual (Page 10)

10
Operating Instructions
Getting Started
Before the fi rst use, you must charge your scooter completely. This should take approxi-
mately 8 to 12 hours.
Getting On/Off
Before getting on or off your scooter, always make sure that the keys are not in the ignition
and that the scooter is off . This is a safety measure to prevent any unwanted injury due to
accidental engaging of levers. Make sure the door is completely closed before moving.
Parking and Locking your E-scooter
When you want to park your e-scooter for a short time, either when you have reached your
destination or are at home, follow these steps:
1. Stop the e-scooter and position it as you want it.
2. Get off the e-scooter, making sure to keep it balanced.
3. Close the door, and use the key to lock it.
Forward and Reverse
First, make sure you are seated comfortably. Put the key into the ignition and turn the
scooter on. You will know that the scooter is active when the LEDs light up on the control
panel. Set your scooter to the lowest speed possible. You may adjust the speed once you
are comfortable with operating the scooter.
Start by gently squeezing the right lever. Gradually apply more pressure to the lever and
the scooter will begin to pick up speed. If you have set your speed to the lowest, your top
speed will be restricted.
Once you are in motion, gently release the lever and the scooter will smoothly come to a
stop. Repeat moving forward and braking a few times to get used to the motion.
Next is to practice reversing. To reverse, gradually squeeze the left lever. Same as before,
the more pressure applied to the lever, the faster the scooter will move. Practice reversing
and stopping a few times to used to the motion.