Daymak Boomerbuggy Covered - Manual (Page 19)

19
Maintenance and Troubleshooting
This section outlines problems you may have and solutions you may be able to use.
Many of the parts in this product are not user-serviceable and should be repaired by
trained professionals. This is especially true of the electrical systems and the mechanical
components. Alteration of these components voids the warranty.
Lubrication
In six-month intervals, you should lubricate the following parts with multipurpose grease
or similar lubricant: seat pivot post and seat release lever.
Do not lubricate the transaxle gears.
Wheels and Tires
The wheels have split rims, which allows easy puncture repair. To change the wheel, re-
move the center 13mm bolt and slide the wheel off its axle. When refi tting the wheel, be
sure to use a locking washer and use locktite or a similar adhesive. When changing a tire,
the inner tube must be defl ated. Remove the four bolts from the wheel and split the rim.
It may be easier – and safer - to have the tubes replaced by your Daymak dealer.
General Maintenance
Every six months, you may need to tighted certain nuts and bolts. The reason for this is
due to the fact that operating the scooter will cause a lot of vibrations, which can gradually
loosen the nuts and bolts on the scooter. The following are some areas that require atten-
tion: tiller base bolts, wheel axle bolts, wheel-to-axle bolts, etc.
Troubleshooting Checklist
If you are having trouble operating your scooter, please check the following:
- The unit is switched on
- All plugs and connectors are fi rmly fi xed
- Battery is fully charged
- Free wheel lever is engaged
- Fuses are not blown
- Check Fault Codes
- Call Daymak Service 1-866-379-7779