Daymak Boomerbuggy Covered - Manual (Page 13)

13
Charging your E-scooter
Charging your e-scooter is a simple process. You require the following:
• The charger that came with your e-scooter.
• A 115V household electrical outlet.
Charger Warning
Only use the chargers that were supplied with your e-scooter. Using chargers that do not
have specifi cations identical to those which came with the e-scooter could irreparably
damage your e-scooter’s battery and electrical systems, and may cause injury.
To charge your e-scooter, follow these steps:
1. Turn off the e-scooter and remove the key from the “ignition.”
2. Plug the female end of the charger cable into the charging slot on the e-scooter.
This is found on the side of the steering wheel on the left side.
3. Plug the male end of the charger power cable into your wall socket. This should
be a115v household electricity supply. You can also use a portable generator, if
necessary, but make sure it provides 115V current.
4. Allow the e-scooter’s battery to charge for the appropriate amount of time (6-12
hours).
5. Disconnect the charger when the LED light on the charger is green. The batteries
have been fully charged.
If your charger’s LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery or
charger may need replacing. Stop charging and bring both to your Daymak dealer imme-
diately. Do not charge the battery.