Daymak Boomerbuggy Falcon - Manual (Page 11)

11
To mount the vehicle, wait for the 4 red indicator lights in the middle to stop fl ashing. Step
onto the unit with one foot to feel the balance. If the unit feels balanced, step on the vehi-
cle with your other foot. Keep your body upright to control the unit and achieve stability.
While holding the handlebars, lean forward and the vehicle should move forward slowly.
Lean backwards and it should gradually come to a stop. The Falcon’s forward and reverse
movement is controlled by the rider’s body movement.
Tilting the handlebar controls the direction of the vehicle. You can also lean your body left
or right while turning the handlebars to maintain balance. The turn rate and turning angle
varies according to speed. In general, the greater the angle of the handlebar, the faster the
turn speed. When reversing, the control direction of the handlebars is reversed.
When dismounting, pull back the handlebar and shift your bodyweight to an upright
position. When the vehicle has stopped completely, remove one foot, while holding the
handlebar to maintain stability, then completely dismount. When the vehicle is on, do not
release the handlebar to remain in control of the vehicle. Remember to shut off the vehicle
completely before dismounting.
Warning
If the Anti-Fall function is in use, the safety strap must be attached to the rider’s body be-
fore stepping on the vehicle; if the vehicle loses balance, the power will shut off .
Operating Conditions and Maintenance
If the alarm goes off and the handlebars vibrate while riding, slow down. When riding for-
ward at excessive speeds, the handlebar and the whole vehicle will automatically begin to
lean backward to lower the speed - this is a normal function to limit the speed.
Before riding, ensure that the handlebar, wheels, batteries, wheel guards and other parts
are installed correctly and securely. Screws may loosen from vibration during operation.
You may need to tighten screws to avoid loss of power, unwanted vibration or other un-
wanted vibration that may cause injury.
While riding, if any abnormal sounds are heard, stop the vehicle, dismount, and check the
entire vehicle before proceeding.
Do not attempt to perform a maintenance check or repair the Falcon. In the event of fail-
ure, please bring it to an authorized professional. Unauthorized repairs or any attempted
repairs by a non-certifi ed professional will invalidate warranties and may incur more re-
pair costs.