Daymak Boomerbuggy Falcon - Manual (Page 14)

14
Calibrating the Balance Point
When riding for the fi rst time or after an extended period, it is a good idea to calibrate the
system to fi nd a balance point. While in the off state, press the power button and the mode
button together for two seconds. After a few “beeps,” the vehicle will calibrate its systems.
At this point, the vehicle shoud level the platform and a fi nal “beep” will confi rm that the
calibration is complete. After calibrating, the system will automatically shut down.
Correcting the platform level and directional data
While in standby mode, press the power button and mode display button until you hear
a “beep.” The display lights shouldturn on - from here you can confi gure 5 diff erent pa-
rameters represented on the battery indicator. The fi rst light adjusts the controls for the
left platform step, the second light controls the right platform. The third and fourth light
adjusts the abatement for both left and right platforms. The fi fth light adjusts the sensi-
tivity of the steering. To increase the values for each, press the display button to gradually
increase the desired parameter. Upon each button press, the light increases in brightness
incrementally.
Set the running time
Press the power button and lock button until you hear a “beep” to enter the setup. The dig-
ital display should read 0. Press the mode key to reduce the number, the power button to
cancel the setting and revert to default, the lock key to save and exit, and the display key
to increase the value.
Digital tube numerical switch
While in standby mode, press the display key to switch the display value - this will display
the value in running time - press it again to cycle display of speed and mileage. To set the
default of which to display on the panel, press the mode key and display key at the same
time while the display is on the desired parameter (running time, speed, or mileage) until
you hear a beep. Press the mode and display key again to save this setting.
Change between high and low speed
By default, the Falcon is set to high speed (20km/h) - press the mode key upon seeing the
frequency display on the panel- the status lights should display a new frequency that rep-
resents low speed mode (10km/h).