Daymak Boomerbuggy Falcon - Manual (Page 13)

13
Annex 1
Using the Remote Control
Locking and Unlocking the Falcon
In standby mode, press the lock key until you hear a “beep” sound. The status lights should
fl ash on the display panel, and the lights will eventually turn off . It is now in the lock state
- an alarm will trigger and the handlebars will vibrate if the vehicle is touched.
To unlock the vehicle, press the lock button on the remote control again. The status lights
on the display panel should turn on.
The top left button controls the power, the lower left
button is the mode key button. The upper right but-
ton locks the vehicle, and the lower right button is the
display key.
In the off -state, press and hold the power button for 5
seconds to hear the buzzer “beep.” The battery indica-
tor lights should turn on.
At this time, the status lights should fl ash. All light in-
dicators may cycle - if this is the case, the systems are
working to properly balance the vehicle. If the lights
continue to cycle, do NOT ride the vehicle - wait for
the status lights to stop fl ashing before riding.
To power off the Falcon, press the power button while
in standby mode and you should hear a beeping
sound before it turns off .