Daymak Boomerbuggy IV - Manual (Page 12)

Daymak Inc. · 130 Oakdale Rd · Toronto, ON · 416-749-2324 · 1-866-379-7779 · www.daymak.com
SAFETY WARNING! When getting on or off the scooter, please make sure that
the key is in the off position to prevent engaging the scooter accidentally. When
seated comfortably, set the speed control knob according to your driving ability.
We recommend that you keep the speed at the lowest setting (fully counter-
clockwise) until you are comfortable with higher speeds.
Getting Started
Before the first use, you must charge your scooter completely. This should take
approximately 8 to 12 hours. Please refer to the Getting to Know Your Scooter
section for information on how to charge your scooter.
Getting On/Off
Before getting on or off your scooter, always make sure that the keys are not in
the ignition and that the scooter is off. This is a safety measure to prevent any
unwanted injury due to accidental engaging of the levers.
For easier mounting or dismounting, lift one of the arm rests before getting on or
off. Return the arm rest to its normal position before operation. Before operating
your scooter, ensure that you are seated in a comfortable position.
IMPORTANT! Do not use the handlebars or the tiller when mounting or
dismounting the scooter. For support, please use the arm rests!
Operating Instructions
Before going on your first trip, spend some time to practice handling your scooter.
Find an open area with plenty of room and no obstacles around. It is
recommended that you have a friend or family member assist you until you are
comfortable to operate the scooter on your own.
Forward and Reverse
First, make sure you are seated comfortably. Put the key into the ignition and turn
the scooter on. You will know that the scooter is active when the LEDs light up on
the control panel. Set your scooter to the lowest speed possible. You may adjust
the speed once you are comfortable with operating the scooter.