MoTeC ADL2 EDL2 - Manual (Page 32)

30 Installation
Telemetry
The ADL2 can transmit telemetry information via a radio link.
• Note that if RS232 ECU communications is used then the telemetry baud
rate must be the same as the ECU communications baud rate (normally
9600 or 19200 baud)
Wiring
Wiring is dependent on the particular telemetry system, please consult the
wiring details supplied with the telemetry system.
ADL2 Setup
Set the RS232 communications for Telemetry Only, or ECU and Telemetry.
The telemetry channels should then be configured in the separate Telemetry
Setup screen, found under the ‘Functions’ menu.