MoTeC BRX - Manual (Page 19)

MoTeC Trouble Shooting 17
• Check that the Receiver is not aimed through glass, as this can
significantly reduce the range.
• Check that the Transmitter and Receiver are aligned correctly, both must
be within 2 ° for 25m operation or 5° for 20m operation.
• Check that the Receiver lens is clean
5. Check Receiver for Interference Signals
Turn the Beacon Transmitter power off and check that the Receiver LED does
not glow dimly under any of the following circumstances.
Note that to see the LED glowing dimly the LED must be shielded from bright
light.
LED glows dimly when a radio is operating
Move the offending radio or radio antenna, or move the beacon
receiver.
LED glows dimly when the engine is running
• Check that the Receiver is mounted using the plastic mounting base
and that the case is not touching any grounded parts.
• Check that the receiver and its wiring are not near the engine
ignition system.