MoTeC SDC3 - Manual (Page 9)

MoTeC SDC3 7 Functionality
For information on configuring the diff temperature override, see Setup | User Modes in the SDC Manager
section.
Fault indication
Faults are indicated by the flashing of the AUTO[-] and AUTO[+] lights above the LCD display on the dash. The
lights will continue to flash until there have been no faults present for 2 seconds.
Fault codes and diagnostic codes are included in the CAN diagnostic messages, as described in Appendix A –
Fault Codes.
ABS Active Detection
The ABS unit transmits status information to the SDC3. ABS Active Detection may be disabled to ignore the
status of the ABS in the diff lock calculation.
See Setup | Input in the SDC Manager section.