Castle AT-5 - Manual (Page 8)

3 Setting Up Your AT-5
Your Castle AT-5 Assembly Table is s
the frame and top inside.
hipped knocked-down, with the legs bolted to a pallet and
3.1 Frame Assembly
CASTLE, INC AT‐5 OWNERS MANUAL V2.1 Page 8 of 26
Fig 1
1. Remove the clamp arm from the pallet by cutting the two zip ties.
2. Unbolt the legs on the narrow side of the pallet and open them to an almost parallel posi-
tion.
3. Lift the table top out and set it aside for later use. Set the two 4x4’s on the floor to prep
for the next step.
4. Unbolt the legs from the pallet.
5. Place the frame face down on the 4 x 4’s so
that the angle iron is facing up (Fig 1)
6. Attach the legs and leg braces to the frame.
7. To attach each of the legs you will need:
a. (2) leg braces [G08516] ,
b. (6) 5/16-18 x 7/8” hex head cap screws [F51878] an
c. (6) 5/16-18 hex nuts [F51628] .
8. Have someone hold the leg or clamp them in place while you fasten the leg to the frame.
The flat part of the angle iron should face the inside of the machine.
9. Next attach the (2) leg support brackets using the bolts supplied. Repeat this process for
the other side.
d