Ke-4, Installation manual – Ultra Start KE-4 User Manual

Page 2

Advertising
background image

Table Of Contents....................................................................................... Page 2
System Contents.
Pre-Installation.
Installation Tips.
Main Wiring Diagram................................................................................... Page 3
Quick Start Installation
................................................................................ Page 4
Wiring Description.
Transmitter Operation.
Transmitter Programming........................................................................... Page 5
System Reset
Quick View Programming Chart
System Programming................................................................................. Page 6
System Programming
.................................................................................. Page 7
Relay Diagrams
........................................................................................... Page 8

- Control Module
- Four Button Remote

Transmitter(s)

- 10-Pin Harness
- Installation Guide
- Owners Manual

System Contents

Key Features

Pre-Installation

Installation Tips

BEFORE STARTING:
- Discuss the optional features of the alarm with the owner of the vehicle.
- Do a walk around of the vehicle. (Note any scratches or dents)
- Check with the vehicle’s owner before installation of LED light.
- See if the owner has a preference for the location of the Valet Switch.
- Have vehicle wiring information ready before starting installation.

- Leave a window open to avoid locking the key’s in the vehicle.
- Use seat covers and floor mats to protect the vehicle.
- Avoid disconnecting the battery.
- Unplug the dome light fuse to prevent battery drain.
- Test all connections with a voltmeter or circuit safe test light.
- Install the wire harness so that it is free of any moving parts.
- Solder all connections. Avoid using scotch-lok and crimp connectors.
- Pull the siren and optional hood pin wires through a factory rubber grommet
into the engine compartment.(Do not use the steering boot).
- Install the siren away from high heat sources and direct exposer to water.

- Keyless Entry With Drivers Door Priority
- Trunk Release Output
- Positive Park Light Output
- Panic Mode
- Horn Honk Output
- Starter Disable Output

KE-4

Installation Manual

Advertising