Ultra Start KE-4 - Manual (Page 5)

KE-4
Installation Manual
QUICK VIEW PROGRAM MENU
SYSTEM RESET
TRANSMITTER PROGRAMMING
Passive / Active Arming Lock-Unlock-Lock-Unlock Passive Active
Passive / Active Locks Unlock-Trunk-Unlock-Trunk Passive Active
Ignition Aouto Door Locks Lock-Trunk-Lock-Trunk ON OFF
Door Lock Pulses Lock-Unlock-Trunk-Lock Three Second .75 Second
Double Pulse Unlock-Trunk-Unlock-Lock Double Pulse Single Pulse
Passive Warning Chirps Lock-Trunk-Unlock-Trunk ON OFF
Reset To Factory Defaults Trunk-Lock-Unlock-Trunk Three flashes Three Flashes
Entering The Program Menu
1) Make sure ignition is in the OFF position.
2) Turn the ignition key ON - leaving key in the ON position.
3) Press the transmitter buttons in the appropriate sequence.
4) After ten seconds the system will automatically exit Program Mode.
To change a Programmable Feature press the transmitter buttons as follows.
*** Default settings are shown in bold lettering.
To add additional transmitters and delete existing transmitter code(s) from memory.
1) Turn the ignition On-Off-On-Off-On-Off-On-Off. The park lights will flash twice.
2) Press the Lock button on the transmitters to be programmed.
3) The park lights will flash once, each time a new transmitter is learned.
*** If this does not happen wait ten seconds and repeat steps 1-3.
Note: Each system can store a maximum of three transmitter codes in memory.
Transmitter Program on “Power Up”
1) Plug in the module. (Leave the ignition in the Off position).
2) Press the lock button on each of the transmitters to be programmed.
3) The park lights will flash once each time a new transmitter code is learned.
Note: Previous transmitters that are not programmed at this time will deleted from memory.
Reset To Factory Default Settings.
1) Make sure ignition is in the OFF position.
2) Turn the ignition key ON - leaving key in the ON position.
3) Press the transmitter buttons as follows. Trunk-Lock-Unlock-Trunk.
4) The system will respond by flashing the park lights three times
The system is now set to factory default settings.