Ultra Start KE-4 - Manual (Page 6)

KE-4
Installation Manual
Setting 1 - Passive/Active Mode (Factory Default Setting: Active Mode)
Passive mode means that the system will automatically arm thirty seconds after
The ignition key is turned off and the last door of the vehicle is closed.
Sometimes referred to as Automatic Arming.
Active mode means that the system will not arm until you manually turn it on by
pressing the lock button on your transmitter.
1. Turn the ignition on. Ignition on means normal driving position.
2. Within 10 seconds, press and release the transmitter buttons
Lock Unlock Lock Unlock in succession.
PASSIVE MODE is confirmed with one horn chirp sound and one light flash.
ACTIVE MODE is confirmed with two horn chirp sounds and two light flashes.
Setting 2 - Passive Lock Mode (Factory Default Setting: Active Lock Mode)
Passive Lock Mode means that all doors will lock automatically when the system
arms in the passive mode.
Active Lock Mode means that doors will lock only with the lock button.
1 Turn the ignition on. Ignition on means normal driving position.
2 Within 10 seconds, press and release the transmitter buttons
Unlock Trunk Unlock Trunk in succession.
PASSIVE LOCK MODE is confirmed with one horn chirp sound and one parking
light flash.
ACTIVE LOCK MODE is confirmed with two horn chirp sounds and two parking
Light flashes.
CAUTION: If the automatic door lock feature is installed and the system is
Programmed to passive lock mode the doors will lock automatically when the
system arms. It is always advisable to remove the ignition key each time you exit
the vehicle.
Ignition Lock Mode means that all doors will lock automatically two (2)Seconds after
the ignition key is turned on and will unlock automatically when the ignition
key is turned off. This assumes that the keyless entry option has been installed
by your Dealer. Sometimes referred to as Ignition Lock.
1 Turn the ignition on. Ignition on means normal driving position.
2 Within 10 seconds, press and release the transmitter button
Lock Trunk Lock Trunk in succession.
DRIVE LOCK MODE ON is confirmed with one horn chirp sound and one parking light
flash.
DRIVE LOCK MODE OFF is confirmed with two horn chirp sounds and two parking
light flashes.
Setting 3 - Ignition Auto Locks (Factory Default Setting: Locks Off)
Entering The Program Menu
1) Make sure ignition is in the OFF position.
2) Turn the ignition key ON - leaving key in the ON position.
3) Press the transmitter button in the appropriate sequence.
4) After ten seconds the system will automatically exit Program Mode.