J&M 500ST - Manual (Page 48)

48
Auto Scale Shutoff Directions
To Toggle Switch
Ground
To Scale Display/Interface
To Valve Body
Deluxe Wireless Remote
•Starts/Stops Motor
•Raise/Lower Conveyer
•Open/Close Tank Doors
•Hydraulic Conveyer
•Auger Swing
•Tip Spout
•Electronic Auto Scale Shutoff
1. Turn Scale Head, Wireless Remote, and Wireless Toggle Switch on.
-The main screen showing gross and tared weight will display.
2. Press and release Scroll on the Wireless Remote.
-The setting for door weight and door selections (front or rear) will display.
3. Press and hold Scroll until the weight value starts to flash.
4. Using the up and down arrows just below the display in the center of the remote,
adjust the desired dispense weight.
5. Press and release Scroll
-The door setting will flash.
6. Using the up and down arrows just below the display in the center of the remote,
select which door you want to dispense from.
7. When settings are acceptable, press and hold Scroll for 3 seconds.
-The main screen will display again.
8. Press conveyer start to dispense the set amount of seed from the desired door.
-The door will automatically shut when the set amount of seed is dispensed
and the conveyor will turn off shortly after.
9. To dispense the same amount of seed from the same door, again press conveyer
start, then repeat the dispense cycle. *If the remote is turned off, steps 1-8 will need to be repeated.
SCROLL
USE THESE BUTTONS
TO ADJUST “DISPENSE
AMOUNT” AND “DOOR
TO DISPENSE FROM”
SETTING
MAIN SCREEN
AUTO SCALE SHUTOFF SCREEN