J&M TF215 - Manual (Page 15)

Pg. 15
To Install the Coil Tine Spring Assembly
Slide the Coil Tine Springs (#22) around the Coil Tine Pipe (#21) and secure at each hole location using
the 1/2” x 3 1/2” J-Bolt (#23) and 1/2” Lock Nut (#16). Repeat for each pipe. Secure the Coil Tine Pipe to
the pivot brackets on the lower end of the harrow arm using the two Squeeze Blocks (#19) and four 1/2” x
4 1/2” Grade 5 Bolt (#20) with 1/2” Lock Nuts (#16).
Below is a recommended layout of the harrow pipe bar and round bar bracket lengths along the
width of the conditioner. Be sure the Harrow is properly and evenly spaced along the Base Unit
Main Frame and Wing Frames, making adjustments as necessary.
Coil Tine Pipe Bar and Round Bar Bracket Layout
for Optional Leveling Harrow
Working
Width Wing Base Unit Wing
Mode
l T
F
2
12’ 6’ 6’
13’ 4’ 5’ 4’
14’ 5’ 4’ 5’
15’ 5’ 5’ 5’
16’ 5’ 6’ 5’
17’ 6’ 5’ 6’
18’ 6’ 6’ 6’
Mo
d
e
l TF
212
20’ 4’ 6’ 6’ 4’
22’ 5’ 6’ 6’ 5’
23’ 5’ 6’ 6’ 5’
24’ 6’ 6’ 6’ 6’
25’ 6’ 6’ 6’ 6’
26’ 7’ 6’ 6’ 7’
27’ 7’ 6’ 6’ 7’
28’ 4’ 4’ 6’ 6’ 4’ 4’
29’ 4’ 4’ 6’ 6’ 4’ 4’
30’ 4’ 5’ 6’ 6’ 5’ 4’
31’ 4’ 5’ 6’ 6’ 5’ 4’
32’ 5’ 5’ 6’ 6’ 5’ 5’
33’ 5’ 5’ 6’ 6’ 5’ 5’
34’ 5’ 6’ 6’ 6’ 6’ 5’
35’ 5’ 6’ 6’ 6’ 5’ 6’
36’ 6’ 6’ 6’ 6’ 6’ 6’
Mo
d
e
l TF
215
37’ 5’ 6’ 5’ 5’ 5’ 6’ 5’
38’ 5’ 6’ 5’ 5’ 5’ 6’ 5’
39’ 6’ 6’ 5’ 5’ 5’ 6’ 6’
40’ 7’ 5’ 5’ 5’ 5’ 5’ 7’
41’ 4’ 4’ 5’ 5’ 5’ 5’ 5’ 4’ 4’
42’ 4’ 4’ 5’ 5’ 5’ 5’ 5’ 4’ 4’
43’ 4’ 5’ 5’ 5’ 5’ 5’ 5’ 5’ 4’
44’ 4’ 5’ 5’ 5’ 5’ 5’ 5’ 5’ 4’
45’ 5’ 5’ 5’ 5’ 5’ 5’ 5’ 5’ 5’