American Standard 2939 - Manual (Page 36)

36 754532-100 Rev. A
BATHING:
• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the optional EZ-Heater,
it will automatically maintain the water temperature.
• IMPORTANT: Do NOT fill the whirlpool more than 2/3 full before getting in, as it may overflow.
• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.
• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is started.
Operating the system without water (dry running) for extended periods will cause pump damage and void the warranty.
• IMPORTANT: The EcoSilent whirlpool will NOT operate unless the water level is at least one inch above
the highest jet.
Operation: EcoSilent Whirlpool with Lights
AIR VOLUME CONTROL ADJUSTMENTS:
• Water turbulence is determined by the amount of air mixed with the water. Rotate the air volume control
counterclockwise for more turbulence, and clockwise for less.
FLOW JET VOLUME ADJUSTMENTS:
• Water flow-levels can be adjusted from vigorous to soft by rotating the nozzle counterclockwise for vigorous and
clockwise for soft.
• The water flow to the mini-jets in the lumbar area of bath (if so equipped) can be adjusted by turning the mini-jet
flow control valve open (counterclockwise) or closed (clockwise). the mini-jets themselves are NOT adjustable.
DISPLAY COLORS
1 ST
2 ND
3 TH
4 TH
5 TH
6 TH
7 TH
8 TH
9 TH
10 TH
11 TH
WHITE
SLOW RAINBOW CYCLE
FAST RAINBOW CYCLE
TURQUOISE
BLUE
MAGENTA
RED
ORANGE
YELLOW
GREEN
RETURN TO SLOW RAINBOW CYCLE
3-BUTTON ELECTRONIC SWITCH
• To start whirlpool pump, press “on” button.
• To stop whirlpool pump, press “off” button.
• To turn on Chromatherapy lights, press light button once. The cycle will start on white.
• Turn off and on within 3 seconds; it will change to slow rainbow cycle and so on per the
display color table shown above.