Hunter 28788 52 Maribel - Manual (Page 8)

8
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
3-2. Insert the downrod pipe through the canopy and adapter cover
with the adapter ring assembled. To keep the adapter ring
assembled, twist the adapter cover around the downrod.
3-3. Loosen the square head setscrew on the adapter to install the
downrod. Note: When the downrod is fully installed, 2-3 threads
on the pipe will still be visible; this is normal. Securely retighten
the setscrew with a wrench or pliers.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-4. Slide the adapter cover down by twisting it around the downrod
until it is flush to the top of the motor housing. Note: When
installing the fan using the 2” downrod, the adapter cover will not
be used.
3-5. Raise the fan and place the hook on the ceiling plate through the
round hole in the rim.
Steps 3-1 – 3-3
Downrod
Canopy
Step 3-4
Round
Hole
Setscrew
Adaptor Cover with
Adaptor Ring
3 • Assembling and Hanging the Fan
42467-01 • 11/26/12 • Hunter Fan Company